Table of Contents
Advertisement
Available languages
Available languages
Cable Requirements
Use a CAT 5 cable with an even sheath. The
Ethernet ports on the DAP-3711 access point
cannot accept a CAT 5 cable that has an uneven
sheath; the RJ-45 connector on the cable will
not fit properly into the receptacle on the
access point.
Configuring the First DAP-3711 in
Access Point Mode
1.
Use an Ethernet cable to connect the
LAN 2 port on the DAP-3711 to the
management computer.
Figure 4: Connecting the DAP-3711
2.
Ensure the computer is configured with
the static IP address 192.168.0.2 and a
subnet mask of 255.255.255.0.
Launch a web browser. Enter 192.168.0.50
3.
in the address field of your browser.
4.
Log in to the administration user interface.
The default login information is:
Username: admin
Password: admin
Quick Installation Guide
5.
Follow the Setup Wizard's instructions
to configure the device in Access Point
Mode. Refer to Figure 5: Using the Setup
Wizard for details.
Figure 5: Using the Setup Wizard
Configuring the Second DAP-3711
in Client Mode
1.
Follow steps 1-4 of the instructions above
to power on the device. Launch the Setup
Wizard to configure the device in Client
Mode.
2 .
T o a void an IP address conflict, change
the IPv4 address so that it is different
from the first DAP-3711's IP address (for
instance, by changing it to 192.168.0.51,
as in the following screenshot).
Figure 6: Changing the IP Address
4
Advertisement
Table of Contents
