The ProBlot 6 and 12 ovens include a drip pan for easy clean-up of accidental spills. Hybridization bottles made of high quality borosilicate glass, which provide a high level of protection against heat and thermal expansion are recommended for optimum ProBlot oven performance.
6.0 Stacking Labnet ProBlot Hybridization Ovens The ProBlot 6 and 12 models may be stacked up to two high. You may wish to remove the adjustable feet from the upper unit when stacking. The adjustable feet can slide off the top of the lower unit and/or scratching can occur if rubber cups or matting are not used.
After setting the temperature, allow at least one hour for the chamber temperature to stabilize and 24 hours for optimum stabilization. Calibration: The Labnet ProBlot hybridization oven is calibrated at 65°C at the factory. The unit can be recalibrated after the ...
Should you have a question about the operation of the Labnet ProBlot™ hybridization oven or if service is required, contact Corning Customer Service. Do not send in a unit for service without first calling to obtain a repair authorization number. Should the unit require return for service, it should be properly packed to avoid damage.
13.0 Limited Warranty Corning Incorporated (Corning) warrants that this product will be free from defects in material and workmanship for a period of one (1) year from date of purchase. CORNING DISCLAIMS ALL OTHER WARRANTIES WHETHER EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE.
Page 8
To request certificates, please contact us at www.labnetlink.com. Warranty/Disclaimer: Unless otherwise specified, all products are for research use or general laboratory use only.* Not intended for use in diagnostic or therapeutic procedures. Not for use in humans. These products are not intended to mitigate the presence of microorganisms on surfaces or in the environment, where such organisms can be deleterious to humans or the environment.