Assembly Issues; Getting Started - Human Touch Robotic Massage iJoy2400 Troubleshooting Manual

Assembly Issues

Getting Started

iJoy-2400 Troubleshooting Guide
iJoy-2400 Troubleshooting
This Troubleshooting Guide walks you step-by-step through the
diagnosis of iJoy-2400 customer problems. It is important to follow
these steps carefully, to ensure that the problem is diagnosed
correctly, and therefore the appropriate repair action is taken.
The backrest reclines but will not incline.
This condition may occur if the chair has been stored below room
temperature, and should self-correct after 48 hours at room
temperature. To speed up this process, recline and incline the chair
several times (pushing the backrest upward when inclining); the chair
should then operate normally.
The power switch will not turn on.
If the power switch cannot be set to On, it is because the child safety
lock is set incorrectly. Set the child safety lock on the power panel to
the Unlock position, then turn the power switch to On.
1. Turn the power switch on the left-hand side of the chair to Off, wait
approximately five seconds, then turn it back On.
2. Check whether any remote control LEDs light. If not, see
on page 2.
"Power"
1