Preparing The Remote Control; Button Battery Replacement; Remote Control Range - Mitsubishi XD80U User Manual

Preparing the Remote Control

Button Battery Replacement

Using the remote control for the first time
The battery compartment is fitted with a transportation insulation sheet at the time of shipping. Pull
out the sheet and remove it. The remote control is now ready for use.
Replacement Method
(A) With the knob pressed to
1
the right side, (B) draw out the
battery case.
(A)
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025) recommended by the manufacturer.
Dispose of used batteries according to your local regulations.
CAUTION
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

Remote Control Range

Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit
and operate.
Reception of the remote control signal should generally be possible within the range illustrated below.
Note
* Exposure of the main unit's remote control sensor or the remote control infrared transmitter to bright light or the obstruction of the signal
by an obstacle located in the pathway may prevent operation.
* The remote control will not function when the battery is exhausted.
Remove the old battery and in-
2
stall a new button battery with (+)
side facing upward in the battery
holder.
(B)
Purchase a CR2025 type battery for replacement.
30°
20°
7m/23.0 feet
Side View
50°
50°
7m/23.0 feet
Remote control sensor
Top View
3
Remote control
sensor
30°
20°
Remote con-
trol infrared
transmitter
6m/19.7 feet
Remote control in-
frared transmitter
E-11
Insert the battery holder into the re-
mote control and push in until the
battery holder closes with a "click"
sound.