Installation - Smeg C3170F2P User Manual

46
Problem
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Replacing the lamp
1. Disconnect the plug from the mains
socket
2. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
1
2
1

INSTALLATION

Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
3. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the
maximum power is shown on the light
bulb cover).
4. Reassemble the lamp cover.
5. Connect the plug to the mains socket.
Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
Cli-
mate
class
SN
Solution
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Ambient temperature
+10°C to + 32°C