Table of Contents
Advertisement
Error Message
Low Temperature
No Device
No device found.
No Ink Cartridge
No Paper Fed
Out of Memory
Cause
The room temperature is too low.
When configuring the Wi-Fi Direct
network, the Brother machine cannot find
your mobile device.
An ink cartridge is not installed correctly.
The machine is out of paper or paper is
not correctly loaded in the paper tray.
The paper was not inserted in the centre
position of the manual feed slot.
The paper in the manual feed slot does
not stay straight when fed.
The Jam Clear Cover is not closed
correctly.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The machine's memory is full.
Action
After warming the room, allow the
machine to warm up to room temperature.
Try again when the machine has warmed
up.
•
Make sure your machine and mobile
device are in the Wi-Fi Direct mode.
•
Move the mobile device closer to your
Brother machine.
•
Move your Brother machine and the
mobile device to an obstruction-free
area.
•
If you are manually configuring the Wi-
Fi Direct network, make sure you have
entered the correct password.
•
If your mobile device has a
configuration page for how to obtain
an IP address, make sure the IP
address of your mobile device has
been configured via DHCP.
Remove the ink cartridge and re-install it
slowly and firmly until it locks into place.
See Related Information: Replace the Ink
Cartridges.
Do one of the following:
•
Refill the paper tray, and then follow
the LCD instructions.
•
Remove and reload the paper, and
then follow the LCD instructions.
See Related Information: Load Paper.
Remove the paper and reinsert it in the
centre of the manual feed slot, and then
follow the LCD instructions.
See Related Information: Load Paper in
the Manual Feed Slot.
Using both hands, adjust the manual feed
slot paper guides to make sure there is no
gap between them and the paper, and
then press Mono Start or Colour
Start.
See Related Information: Load Paper in
the Manual Feed Slot.
Make sure the Jam Clear Cover is closed
evenly at both ends.
See Related Information: Printer Jam or
Paper Jam.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
If a copy operation is in progress:
•
Press
or Quit and wait until the
other operations that are in progress
finish, and then try again.
•
Press Partial Print to copy the
pages scanned so far.
236
Advertisement
Table of Contents
