Indicators - Mitsubishi Electric XD300U User Manual

Indicators

The projector has two LED Indicators which show the
working condition of the projector.
The below table offers solutions to possible problems.
If a problem persists, turn the projector off and consult
your dealer.
Normal condition
Power STATUS CONDITION
Stand-by
Steady
Off
red
Lamp stand-by (about for 1 minute)
Steady
Blinking
green
green
The POWER is ON. (Normal condition)
Steady Steady
green green
Abnormal condition
Power STATUS CONDITION
Unusual temperature
Steady
• The ventilation slits or air filter is clogged with
green
or
• The room temperature is too high.
Blinking
orange
• The filter is dirty.
Steady
red
The protection circuit is working or the lamp is in an
abnormal condition.
Steady
red
Blinking
green
The lamp operation time exceeds the time elapsed until the
Steady
lamp shutdown notice. (See page 24.) The POWER is on.
Blinking
green
green/red
The lamp operation time exceeds the time elapsed until the
lamp shutdown notice. (See page 24.) The POWER is off.
Steady
Blinking
red
red
The lamp operation time exceeds the time elapsed until the
lamp shutdown. (See page 24.)
Steady
Steady
red red
The lamp cover is not closed.
Off
Blinking
green/red
Abnormal.
Steady
or
Blinking
green/red
Blinking
EN – 26
dust or debris.
POWER LAMP/TEMP
STATUS
COMPUTER MENU
AUTO
{
POWER POSITION
$ KEYSTON/
%
VIDEO
ENTER
}
Notes
The power button cannot be used to switch
ON and OFF
POSSIBLE SOLUTIONS
• Remove the object from the ventilation
slits.
• Relocate the projector to a cooler place.
• Clean the filter.
• Wait until the STATUS indicator is turned off,
then press the POWER button.
• If the above operation is not effective,
replace the lamp.
Replace the lamp.
Exchange with a new lamp if the same
problem recurs.
Close the cover correctly.
Contact your dealer.
Power indicator
STATUS indicator