Ford Ranger 2008 Owner's Manual page 217

RANGER_F8M1-10-08I_Edition1 Page217
Friday, September 26 2008 3:7 PM
3. Detach the electrical connector from
the unit by pulling it to the rear.
4. Install the new side direction indicator
unit.
5. Insert the front end of the unit into the
vehicle and press in the rear end.
NOTE
Bulb replacement is not possible
because it is built into the unit. Replace
the unit.
(LED type)
Due to the complexity and difficulty of
the procedure, the LED bulbs should be
replaced by an expert repairer, we
recommend an Authorised Ford Repairer.
High-mount brake light
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Place an index finger into each notch
and pull the high mount brake light
component outward.
Form No.F8M1-10-08I
3. Press the cover downward to remove it.
4. Remove the screws with a Phillips
5. Turn the socket and bulb assembly
6. Disconnect the bulb from the socket.
í
Black plate (217,1)
Maintenance and Care
Owner Maintenance
screwdriver and then remove the high
mount brake light component.
anticlockwise and remove it.
í
Some models.
8-31