Operating Range For The Remote Control; Handling The Remote Control; Cat5 Tx Box; English - Mitsubishi Electric MDT521S User Manual

< Operating Range for the Remote
Control >
Point the top of the remote control toward the LCD monitor's
remote sensor during button operation.
Use the remote control within a distance of about 7 m/23 ft.
from the front of the LCD monitor's remote control sensor
and at a horizontal and vertical angle of within 30° within a
distance of about 3 m/10 ft.
CAUTION:
Important, the remote control system may not function when
direct sunlight or strong illumination strikes the remote control
sensor of the LCD monitor, or when there is an object in the
path.
< Handling the remote control >
* Do not subject to strong shock.
* Do not allow water or other liquid to splash the remote
control. If the remote control gets wet, wipe it dry immedi-
ately.
* Avoid exposure to heat and steam.
* Other than to install the batteries, do not open the remote.

CAT5 Tx BOX

USB (B type)
Connected to the USB connector (A type) of the computer.
CAUTION:
We have checked the operation of the USB connector by
connecting it with our computers according to the USB stan-
dards.
When the CAT TX5 BOX is combined with your computer
system or USB hub system, check in advance that it operates
properly.
EXTERNAL CONTROL IN (mini D-Sub 9 pin)
Connected to the RS-232C OUT connector of the computer.
Note:
RS-232C connection isn't necessary when the COM port
number set by the USB driver is used. Make selection using
30° 30°
the input select switch (USB/RS-232C), as necessary.
RGB IN (mini D-Sub 15 pin)
To input the analog RGB signals from other monitor.
RGB OUT (mini D-Sub 15 pin)
To output the analog RGB signals from a computer.
Input select switch (USB/RS-232C)
Switches the control input between the USB connector and
the RS-232C connector.
CAT5 OUT (modular connector 8 pin)
Connected to the CAT5 (RGB5) IN connector of MDT521S.
Composite sync signal level switch
Switches the composite sync signal level.
The TTL level and the 0.3V level are switched.
Auxiliary power supply input connector (DC IN
5 V)
Though the power is supplied from the above-mentioned
USB connector, an auxiliary DC power adopter (commercially
available) is also available. Power can be drawn from the USB
connector and the auxiliary power supply at the same time.
CAUTION:
The auxiliary power supply input connector isn't intended for
general use. Commercial DC power connectors are available
in different shapes. When you want to use this connector,
consult a qualifi ed electrician in advance.

English-9