Page 1
Quectel GPS Engine sales@eddywireless.com EVB User Guide L20_EVB_User_Guide_V1.0...
Page 2
L20_EVB_User_Guide_V1.0 General Notes Quectel offers this information as a service to its customers, to support application and engineering efforts that use the products designed by Quectel. The information provided is based upon requirements specifically provided to Quectel by the customers. Quectel has not undertaken any independent search for additional relevant information, including any information that may be in the customer’s possession.
L20 EVB User Guide 1. Introduction This document defines and specifies the usage of L20 EVB (Evaluation Board). Customer can get useful information about L20 EVB and GPS demo tool from this document. 1.1. Reference Table 1: Reference Document name...
L20 EVB User Guide 3.2. UART Interface Figure 5 : UART interface Table 3: Pins of UART port Signal Description TXD(RS232) Transmit data RXD(RS232) Receive data L20_EVB_User_Guide_V1.0 - 11 -...
L20 EVB User Guide Table 4: Switches and buttons Part Name Description POWER Control power supply from adapter 3.5. Operating Status LEDs Figure 8: Operating status LEDs Table 5: Operating status LEDs Part Name Description Flash: GPS Data export from TXD...
L20 EVB User Guide 3.6. Test Points Figure 9: Test points J102 & J104 Table 6: Pins of J102 & J104 Signal Description TXD1 Transmit GPS data RXD1 Receive GPS data Supply voltage to module L20_EVB_User_Guide_V1.0 - 14 -...
L20 EVB User Guide 4. EVB and Accessories T he EVB and its accessories are equipped as shown in Figure 10. Figure 10: EVB and accessory equipments L20_EVB_User_Guide_V1.0 - 15 -...
The SiRFLive tool can help user to view the status of GPS receiver and record NMEA data. The steps of using SiRFLive for L20 are described as below: 1. After finishing assembling the EVB as figure 10, connect the RS232 to USB cable to PC, and power on the module, the LED GPS_TXD_DATA will be flash.
Page 18
L20 EVB User Guide 3. The operation window will show NMEA data, Signal view, Radar view, Location map and Position information including UTC, latitude, longitude, altitude, HDOP, speed and so on. 4. Click button , the reset window will pop up as below: L20_EVB_User_Guide_V1.0...
Page 19
L20 EVB User Guide 5. Select reset mode and click “Send” to implement Cold Start, Warm Start or Hot Start. Save NMEA data with below toolbar: 6. Record log and Stop log with below menu: L20_EVB_User_Guide_V1.0 - 18 -...
Need help?
Do you have a question about the L20 and is the answer not in the manual?
Questions and answers