Cleaning The Loading Door And The Drum; Cleaning The Body And Control Panel; Cleaning The Water Intake Filters - Beko BFLB904ADW User Manual

4. Gently push the drain stick into the slot
behind the detergent compartment.
5. The detergent will start to pour into the
container.
6. The same is carried out for the softener
compartment.
7. The guides holding the top cover of the
detergent drawer are removed with a
flathead screwdriver (there are total of 6
guides, two each on the right, left and
back of the drawer) and the inside of the
drawer is washed.
8. After the completion of the washing pro-
cess, the cover is inserted to the drawer.
Make sure that all guides are in place. If
the guides do not fit, liquid may spill
from the drawer, or the detergent box
may get trapped in the drawer rail or
move in difficulty. Therefore, make sure
that the guides are firmly seated.
9. Insert the drain stick back into its slot in
the back of the drawer.
10.Refit the drawer by paying attention to
its slot and slides and push the drawer
to close. Once detergents and softeners
are added, they will be ready for use in
dosed programs.
7.2 Cleaning the Loading Door and the
Drum
For products with drum cleaning pro-
gramme, please see the Operating the
product section.
Repeat Drum Cleaning process in
every 2 months.
NOTICE: Use an anti-limescale
suitable for the washing machines.
After every washing make sure that no for-
eign substance is left in the product.
If the holes on the door gasket shown in the
figure is blocked, open the holes using a
toothpick.
Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents for
stainless steel.
Never use steel wool or wire wool. These
will damage the painted, chrome coated
and plastic surfaces.
We recommend you to wipe the door gas-
ket with a dry and clean cloth at the end of
the programme. This will remove residues
on the door gasket in your machine and
prevent formation of malodours.
7.3 Cleaning the Body and Control
Panel
Wipe the body of the product with soapy
water or non-corrosive mild gel detergents
as necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel. Do not use cleaning products
that contain bleach

7.4 Cleaning the Water Intake Filters

There is a filter at the end of each water in-
take valve at the rear of the product and
also at the end of each water intake hose
where they are connected to the tap. These
filters prevent foreign substances and dirt
in the water to enter the product. Filters
should be cleaned if they are dirty.
EN / 39