Permit Needed; Toll Roads; Cross-Border Planning; Language & Units - Mio DigiWalker C310 Software Manual

Turning back on dual carriageways is not considered as a u-turn.
Note: Via points are handled as stopovers with regards to u-turns. It means disabling
u-turns on this page will avoid u-turns during the entire route if possible, but when
reaching a via point, the following part of the route may be planned starting in the
opposite direction.

6.3.3.5 Permit needed

To use some roads or enter some areas you may need special permit or permission
from the owners. These roads are excluded from your routes by default. Use this
switch if your vehicle is authorized to enter.

6.3.3.6 Toll Roads

Toll roads are included in your routes by default. If you wish to travel more to avoid
paying a toll, disabling them will make MioMap plan the best toll-free route for you.

6.3.3.7 Cross-border Planning

By default MioMap plans routes using the border crossing points. However if you live
near the border, you can disable border crossing with this switch to remain within
one country.
6.4 Language & Units
Here you can set the languages, measurement units, and date and time formats
used by MioMap.

6.4.1 Program language

This button displays the current written language of the program. By tapping the
button you can select from a list of available languages. MioMap will have to be
restarted if you change this setting. MioMap will ask for confirmation before it
restarts.
76