Video Conference - Minox DD1 Instruction Manual

white snow landscape is compressed to a much higher
degree that a meadow of flowers which is rich in color
and high in contrast.
Please observe the following instructions to select the
right image compression:
1. Switch on the DD1 by pressing the On/Mode button.
2. Press the On/Mode button until the mode "Sp" or
"Fn" appears. If the DD1 is in the high-compression
mode (Sp) the display indicates the optional selection
"Fn" for the low compression (Fn) and vice versa.
3. Press the shutter release to accept the respectively dis-
played mode. A signal beep confirms the adjustment.
The following gives a few possible combinations
of image resolution and image compression:
Lr + Fn = poor image quality, small amount of storage
space, high number of images
Hr + Fn = Recommended for standard image quality,
medium storage space, medium number of
images
Hr + Sp = very high image quality, large amount of
space, low number of images
14
Important note
1) Please observe that the display always indicates the
new mode to be selected and not the currently active
camera mode.
2) After each shot the image counter recounts the
remaining number of images available. Based on the
different storage quantities and image sizes described
above, the new number of images may differ from the
respective previous number. This is not a camera fault.

Video conference

Your DD1 can be used as Web Cam for video conferen-
ces. Please follow the instructions given below for this
purpose.
1. Switch on your DD1 by pressing the On/Mode button.
2. Press the On/Mode button until the mode
for video conferences "VC" appears.
3. Press the shutter release to confirm and set this
mode. The flashing stops and "VC" is displayed.
4. Connect the Camera to your PC via the provided
USB cable.
5. Start the ArcSoft PhotoImpression* software as
follows: Start > Programme > ArcSoft
PhotoImpression > PhotoImpression.
*not included in scope of delivery. Optionally available from MINOX Germany