Table of Contents
Advertisement
Warning signals
Replace battery
Once the power of the battery drops below a standard
power level, the warning signal "Lb" is displayed. This
means the battery of your DD1 will soon be empty and
must be replaced. You will hear an acoustic signal and
ten seconds later the camera will automatically switch
into off mode.
Memory full
When the image memory of your DD1 is full, the image
counter displays "00".
Important information on use
The camera automatically switches back to camera
mode (with LCD displaying 2 digits) if there is no signal
within ten seconds and the camera is not connected to
the PC.
Shooting and deleting images
Prior to shooting pictures with the DD1 always check
that the battery has sufficient power. Always observe
the following instructions when shooting images:
1. Switch on your DD1 by pressing the On/Mode
button once. The LCD display of your camera
shows the image counter. The image counter counts
down and indicates the number of shots left.
2. Compose your picture subject in the viewfinder.
3. Hold the camera steady and press the shutter
release to shoot the image.
4. An acoustic signal confirms the image has been
taken correctly.
5. When you let go off the release button you will see
that the image counter now indicates one (or more)
shot less which shows that the picture has been taken.
Note
After an image is captured, the image counter will show a
decrement. The number of decrement depends on the size
of the image captured. It will decrease by at least 1. For
Super / Fine High Resolution mode, the image counter will
decrease from 40. For Fine Low Resolution mode, the ima-
11
Advertisement
Table of Contents
