Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ZKTeco LD01
Summary of Contents for ZKTeco LD01
- Page 2 Copyright© 2020 ZKTECO CO., LTD. AII rights reserved. Without the prior written consent of ZKTeco, no portian of this manual can be copied or farwarded in any way or farm. AII parts of this manual belong to ZKTeco and its subsidiaries (hereinafter the "Company" or "ZKTeco").
- Page 3 Dual Loop Detector LD0l User Manual ZKTeco shall in no way be responsible (i) in case the machine/unit/equipment malfunctions dueto any non-compliance of the instructions contained in this manual (ii) in case of operation of the machine/unit/equipment beyond the rate limits (iii) in case of operation of the machine and equipment in conditions different from the prescribed conditions of the manual.
- Page 4 User Manual About the Company ZKTeco is one of the world's largest manufacturer of RFID and Biometric (Fingerprint, Facial, Finger-vein) readers. Product offerings include Access Control readers and panels, Near & Far-range Facial Recognition Cameras, Elevator/floor access controllers, Turnstiles, License Plate Recognition (LPR) gate controllers and Consumer products including battery-operated fingerprint and face-reader Door Locks.
- Page 5 The general information which helps in performing the operations faster The information which is significant Care taken to avoid danger or mistakes The statement or event that warns of something or that serves as a cautionary example. Page Copyright©2020 ZKTECO CO., LTD. AII rights reserved.
-
Page 6: Table Of Contents
FRONT PANEL INDICATOR ......................... 1O INSTALLATION GUIDE ........................... 11 OPERATIONAL CONSTRAINTS ........................11 LOOP AND FEEDER SPECIFICATION ........................11 SENSING LOOP GEOMETRY ..........................11 LOOP INSTALLATION ..........................12 CONFIGURATION ........................... 14 LD01 DETECTOR CONNECTOR......................... 14 Page Copyright©2020 ZKTECO CO., LTD. AII rights reserved. -
Page 7: Installation Instructions
The unit has a number of initial selectable options for configuration of the relay outputs. The LD01 provides visual outputs ( LED) on the front of the enclosure and relay change-over contacts at the 11 pin connector at the rear of the enclosure. The power LED indicates that the unit has been powered. -
Page 8: Switch Setting Selections
± ± ±... -
Page 9: Automatic Sensitivity Boost
Should it be necessary to retune the detector, as may be required after the changing of frequency switch selections or after moving the detector from RESET switch will initiate to the automatic tuning cycle. installation to another, momentary operation of the Page Copyright©2020 ZKTECO CO., LTD. AII rights reserved. -
Page 10: Front Panel Indicator
Link Selection There are 3 link positions located inside the LD01 which are used to alter the output relay configuration of the detector. The links have been placed inside the unit to avoid incorrect operation due to selection by an unauthorised operator. -
Page 11: Installation Guide
This is extremely important for reliable detector performance. Sensing Loop Geometry Sensing loops should, unless site conditions prohibit, be rectangular in shape and should normally be installed Page Copyright©2020 ZKTECO CO., LTD. AII rights reserved. -
Page 12: Loop Installation
100 metres. lt should be noted that the loop sensitivity decreases as the feeder length increases, so ideally thefeeder cable should be kept as short as possible. The loops are sealed using a "quick-set" black epoxy compound or hot bitumen mastic to blend with the roadway surface. Page Copyright©2020 ZKTECO CO., LTD. AII rights reserved. - Page 13 14L.. l------------------l4-f-------,-"'4 SAWCUTS CUR9,'l(WJ EDGE & " .,,,, 45° OROSSCIR' TO PltOYllE STRESS RELEF Figure 5.1 Adj,a e nt loops conne,cted different detector modules SURFACE Loop Sealant 3Jt.:Jrnsot LoopCable Figure S]ot detail Page Copyright©2020 ZKTECO CO., LTD. AII rights reserved.
-
Page 14: Configuration
12-24V input Neutral AC/DC Channel2 Common No Use Channel 1 Common Channel 1 Channel 1 loop Twist Channel 1 loop this pair Channel2 loop Twist Channel 2 loop this pair Channel2 a g e Copyright©2020 ZKTECO CO., LTD. AII rights reserved. - Page 15 ZKTeco Industrial Park, No. 26, 188 Industrial Road, Tangxia Town, Dongguan, China. Phone : +86 769 - 82109991 : +86 755 - 89602394 www.zkteco.com Copyright© 2020 ZKTECO CO., LTD. AII Rights Reserved.