Table of Contents
Advertisement
25. FOR SCHEMATIC DIAGRAM
25.1. Base Unit
1. DC voltage measurements are taken with an oscilloscope or a
tester with a ground.
2. The schematic diagrams and circuit board may be modified at any
time with the development of new technology.
Important Safety Notice:
Components identified by
for safety. When replacing any of these components, use only the
manufacturer´s specified parts.
25.2. Handset
(SCHEMATIC DIAGRAM
1. DC voltage measurements are taken with an oscilloscope or a
tester with a ground.
2. The schematic diagrams and circuit board may be modified at any
time with the development of new technology.
26. SCHEMATIC DIAGRAM (Base Unit)
26.1. Base Unit
26.2. RF Unit (Base Unit)
27. SCHEMATIC DIAGRAM (Handset)
27.1. Handset
27.2. RF Unit (Handset)
28. CIRCUIT BOARD (Base Unit)
28.1. Component View
28.2. Flow Solder Side View
29. CIRCUIT BOARD (Handset)
29.1. Component View
29.2. Flow Solder Side View
(SCHEMATIC DIAGRAM (Base
mark have special characteristics important
Unit))
(Handset))
63
Advertisement
Table of Contents
