Samsung HW-Q990B Full Manual page 9

7
Sound Control
8
Play / Pause
9
Up/Down/Left/
Right
10
Info
11
WOOFER LEVEL
12
VOLUME
13
TONE CONTROL
By pressing the button, you can set the audio function such as Auto EQ, Spacefit sound, AVA, Voice enhance
mode, Night mode, Sync, Surround speaker mode, Virtual. The desired item can be adjusted using the Up/Down
buttons.
• You can use the Auto EQ function if a subwoofer is connected.
• Voice enhance mode enhances spoken dialog in movies and TV to make it easier to hear.
• Night mode is optimized for night time viewing with the settings adjusted to bring the volume down but keep
the dialog clear.
• Press and hold the (Sound Control) button for about 5 seconds to adjust the sound for each frequency band.
150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are selectable using the Left/Right buttons and each
can be adjusted to a setting between -6 to +6 using the Up/Down buttons.
(Make sure the Sound mode is set to "Standard".)
• If the video on the TV and audio from the Soundbar are not synchronized, select Sync in Sound Control, and
then set the audio delay between 0~300 milliseconds by using the Up/Down buttons.
• Sync is only supported for some functions.
• Available Surround speaker mode settings may vary depending on the specification of the compatible (with
the Soundbar) surround speaker.
• The Virtual Speaker function can be turned ON/OFF by using the Up/Down buttons.
You can also play or pause music by pressing the button.
Press the indicated areas to select Up/Down/Left/Right.
Press Up/Down/Left/Right on the button to select or set functions.
• Music Skip
Press the Right button to select the next music file. Press the Left button to select the previous music file.
• ID SET
Use this option when the Subwoofer or Surround Speakers are not connected or need reconnection.
While powered off, press and hold the Up button for 5 seconds to perform ID SET. (See page 14.)
Press to display information about the active function or the codec available.
In BT mode, it displays the connected device (when pairing is complete) or "BT ready" (when pairing is required).
Push the button up or down to adjust the level of the woofer (bass).
Push the button up or down to adjust the volume.
• Mute
Press the VOL button to mute the sound. Press it again to unmute the sound.
By pressing the button, you can adjust the volume of the treble or bass sound. The defired item can be adjusted
using the Up/Down buttons. This function is enabled in Sound mode excluding in Standard mode.
• To control the volume of the treble or bass sound, select TREBLE or BASS in Sound Settings, and then adjust
the volume between -6~+6 by using the Up/Down buttons.
• Once the bass level is changed, the woofer level will be also adjusted accordingly.
ENG - 9