Table of Contents
Advertisement
A 5 Handling
A 5.1 Technical data
Model Trimmer EWL 5831
1.000.8422 DE (electrical supply line 0.223.4118)
Model Trimmer EWL 5831
1.000.9674 GB (electrical supply line 0.691.3601)
Model Trimmer EWL 5831
1.000.9679 US
Model Trimmer EWL 5831
Motor consumption:
900 watts
Voltage:
230 volts / 50 Hz
Revolutions:
3,000 rpm
Weight:
22.2 Kg
Dimensions
Width:
325 mm
Height:
340 mm
Depth:
385 mm
Hand rest:
120 mm protruding
Technical modifications reserved
Noise emissions from the unit were measured within a radius of 1 metre, and at a height of 1.60 metres. In a time-related average of 50%
free-running, 30% medium load and 20% full load, these amounted to 69 db(A). The noise-recordings were carried out in accordance with
DIN 45635 Part 1.
• Wait a few seconds after switching on until the motor has reached full speed, so that the full torque can be used.
• Do not press the models too hard on the disc, so that the motor stalls.
• This can lead to a possible overload, and damage the motor.
.
A 5.2 Water control
The water supply is regulated by a faucet.
The volume of water is sufficient when, during trimming, the disc roughly retains its natural colour.
Trimming of the model is best achieved by applying only light pressure and using small left/right movements.
Naturally, only fully-hardened plaster models should be trimmed, as soft plaster can lead to blockages in the drainage system.
EWL 5831
GB
OPERATING INSTRUCTIONS
(electrical supply line 0.223.4144)
AU (electrical supply line 0.223.4145)
5
Advertisement
Table of Contents
