Advertisement
[ Disassembly of Frame]
(1) Removing Safety guide and Saw blade, reverse the main body , and take away Pointer A, Lever 80, Knob 45.
(2) When removing
Hex. Bolt M6x14 (4 pcs) attaching for Table by Spanner10, Frame will come off.
Used tools for the above disassembly:
driver,
driver, Spanner 10-13, Spanner 22, Spanner 19,
Spanner 17, Hex. Rod wrench 6, Retaining ring plier
N
ote in assembly
(1) Stick Flat washer 40 on Gear housing cover with grease for installation.
(2) Be sure to apply grease only on the teeth in Gear housing. Do not use too much grease, which may cause heat or over-
flow.
(3) Installation of Lever 80
a)Decide the fastening angle of Lever 80
•Do not fasten Bolt completely ( be careful of Left-
turn screw)
•Put both Nuts and Lever 80 to decide the position.
b)Fasten Bolt
•Heighten Lever 80 and loosen both Nuts.
•Fasten up Nut 1 and Bolt firmly using Hex. Rod
wrench 6..
c) Fasten Nut 2 to Nut 1 side
•Put Spanner 22 on Nuts and fasten up Nuts firmly
using Lever 80 together.
Nut 1
Nut 2
30 ~45
Fasten
Loosen
Advertisement
