Table of Contents
Advertisement
HCD-M90
DECK SECTION
0 dB=0.775 V
Note: Confirm each contents of this section first of all. If the results are
not satisfied, do the adjustment.
1. The adjustments should be performed with the rated power supply
voltage unless otherwise noted.
2. The adjustments should be performed in the order given in this service
manual.
3. The adjustments should be performed for both L-CH and R-CH.
REC BIAS ADJUSTMENT
Procedure:
1. Mode: REC
FUNCTION: MD
MAIN board
AUDIO IN (MD/VIDEO) jack (SJ302)
L-CH, R-CH
1) 315 Hz
2) 10 kHz
AF OSC
600 Ω
attenuator
2. Mode: Playback
recorded
portion
set
MAIN board
SPEAKER terminals (SJ301)
L-CH, R-CH
3. Confirm playback the signal recorded in step 1 become speci-
fied values as follows.
If these values are out of specification values, adjust the RV101
(L-CH) and RV201 (R-CH) on the TC board to repeat steps
1and 2.
Specified values: Playback output of 315 Hz to playback
output of 10 kHz: ± 0.5 dB
Adjustment Location: TC board
– TC BOARD (Component Side) –
RV101 (L)
28
50 mV (– 23.8 dB)
blank tape
CN-123
set
level meter
+
–
REC Bias
Adjustment
RV201 (R)
Advertisement
Table of Contents
