Table of Contents
Advertisement
To charge through the MIC Jack :
- Connect the AC Adaptor/Charger into an A/C Wall Outlet
- Insert the Adaptor/Charger jack into the MIC Jack of the radio found at the side of the unit.
To charge through a Desktop Charger:
- Connect the AC Adaptor into an A/C Wall outlet
- Insert the Adaptor Jack into the Desktop charger jack
- Place the units into the Desktop Charger slot and note that the LED indicator of the Desktop
Charger will light up to indicate charging function.
Note :
1.
Only use batteries indicated in the manual, or our NiMH battery pack. (see page 4)
2.
Do not attempt to charge Alkaline batteries or any batteries or battery packs other than the
one indicated in the manual. This may cause leakage and damage the unit.
3.
For long term storage of the radio, turn the unit OFF and remove the batteries from the
radio.
Operation
: Press the
Power On/Off
on. Press the button
for over 3 seconds to turn the radio off.
Volume : Press the
button to increase the volume, and press the
to decrease the volume during normal operation.
Talking and Listening : To communicate, all radios in your group must be set to the
same channel and CTCSS Code.
•
For maximum clarity, hold the radio 2 to 3 inches from your mouth.
•
Press and hold PTT button and speak in a normal voice into the microphone.
The TX icon will appear continuously on the LCD Display when transmitting.
•
To receive messages, release the PTT button. The RX icon will appear on the
display when your radio is receiving a transmission.
Monitor button : Pressing and holding the
hear noise so you can adjust the volume level of the radio when not receiving a
signal. The
should be used to check activity on current channel before
transmitting. Press and hold the
Call Tone : Your G-300 can transmit a call tone for a fixed length of time. To send a
call tone, press the PTT twice rapidly. The TX icon will appear during transmitting a
call tone and tone can be heard on the speaker for confirmation.
Scan : Your G-300 can scan all of the 22 channel to observe for any activity. To
enter the scan mode, press the
one second to exit the scan mode.
Your radio will rapidly scan each of the 22 channels and stop on any active channel.
When you press the PTT button to transmit on an active channel, the scanning function
will stop. To resume scanning Press and hold the
Keypad Lock : To avoid accidentally changing the radio operation, press the
button for 5 seconds . The
When the
is on the menu function the
When locked, you will be able to turn the radio off and on, monitor, transmit/receive,
and send a call tone. To unlock, press the
Backlit LCD : Your G-300 comes with a backlit LCD Display to enable you to view
the setting in a dark environment. The backlighting can be turned on/off by pressing
the
button and releasing. The backlighting will turn on for 5 seconds.
User Interface
To access the advanced features of your G-225/227, your radio has the following
menu functions:
Mode
Channel
CTCSS
1~22
0~38
button for more than 1 second to turn the radio
button for 2 seconds will let you
for 2 seconds to return to normal operation.
button for one second. Press
button for one second.
icon will appear on the display after the second beep.
and
for 5 seconds.
G-227 only
Power
VOX
Hi/Lo
On/Off
button
button again for
button will be disabled.
Vibrate
Roger
On/Off
On/Off
Advertisement
Table of Contents
