Microtek CX6 Quick Start page 3

2 5
M C
AKE ONNECTIONS
Warning:
As a safety precaution, disconnect all
power to the projector and connecting
devices before making connections.
Label
Connect the supplied DVI
1.
DVI-I in
cable from a computer.
Connect an RGB cable
RGB in
2.
from a computer (not sup-
plied).
Connect an RGB cable (not
RGB
3.
supplied) to an external
out
monitor.
Reserved service port for
4.
RS-232
firmware upgrades.
Connect the supplied USB
5.
USB
cable from a computer.
Connect an audio cable
Audio-
(not supplied) from the
6.
in
computer's audio-out con-
nector.
Connect an audio cable
Audio-
7.
(not supplied) to audio-in
out
port of a amplifier device
Connect an audio cable
L-
8.
(not supplied) from a video
Audio-
device.
R
Connect a composite video
Video
9.
cable (not supplied) from a
in
video device.
Connect the supplied S-
10. S-video
video cable from a video
device.
Connect a component video
Compo-
11.
cable (not supplied) from a
nent
video device.
Video in
Description
— Q u i c
— Q u i c
6
P
OWER ON
1.
Connect the power cord to the
projector (A). Connect the other
end to a wall outlet.
Turn the main power switch on
(B).
The Power LED and Lamp-ready
LED turn on.
2.
Turn on the connected devices.
3.
Ensure the Lamp-ready LED is
orange (not flashing) and then
press the Power button to turn
on the projector (B).
The projector splash screen
displays and connected devices
are detected.
4.
Press the Menu button and then
press the cursor
Language is highlighted (C).
5.
Press the cursor
the language you want is
highlighted (D).
6.
Press the cursor ENTER button
to confirm the language.
7.
Press the Menu button twice to
close the OSD.
8.
To turn off the projector, press
the power button once and then
again after the prompt. Then,
turn off the main power switch.
k S t a r t G u i d e
k S t a r t G u i d e
/ S
OFF AND ET
—
—
L
ANGUAGE
button until
button until