Rear Panel Connections - Redback A 4506 Operating Manual

3.0 Rear Panel Connections

Manufactured in Australia
By Altronic Distributors Pty. Ltd.
24V Auxilliary
www.altronics.com.au
Outputs
Model AC Fuse (M205)
(Total maximum
A 4506
5A
Load = 1 Amp)
A4512 5A
Out
Out
1
2
- + - +
CAUTION
!
RISK OF ELECTRIC SHOCK
OPEN BY QUALIFIED
240V AC
PERSONNEL ONLY
1 2
1 240V AC Input
Power is supplied via a 230V mains lead.
2 24V Auxiliary Outputs
These provide 24V DC at a maximum of 1 amp combined output current.
3 Low Battery and Mains Fail Contacts
Normally open contacts which close when a low battery condition occurs or when mains is no longer powering
the charger.
4 Battery Voltage Connection
This lead must be connected to the batteries via a separate cable to that which is connected to the battery +ve
and battery -ve binding posts. This separate lead accurately measures the voltage present at the batteries.
5 Battery -ve Connection
This is connected to the negative terminal of the battery.
6 Load -ve Connections
These binding posts are for the negative connection of the load(s). A maximum load of 50 amps per set of load
terminals.
7 Load +ve Connections
These binding posts are for the positive connection of the load(s). A maximum load of 50 amps per set of load
terminals.
8 Battery Isolate/Reset
This breaker can be used as an isolator to quickly disengage the batteries without having to disconnect leads. It
also acts as a safe guard against short circuits in the battery leads or reverse polarity connection.
9 Battery +ve Connection
This is connected to the positive terminal of the battery.
5
Separate cable to run to battery
for accurate voltage indication.
THIS MUST BE
CONNECTED FOR
CORRECT OPERATION
Battery
Low Mains
Voltage
Batt. Fail
BATTERY (-VE)
Unit suitable for use with Sealed Lead Acid (SLA)
+ –
Contacts close
NOTE: Only use batteries of the same make and capacity.
on Alarm
Conditions
3 4
6
7
LOAD 1 (-VE) LOAD 2 (-VE)
Please Note:
batteries only.
24V SYSTEM ONLY
Fig 2
LOAD 1 (+VE)
(max load current 50A) WATERPROOF
100A
LOAD 2 (+VE)
(max load current 50A)
8
Redback® Proudly Made In Australia
Battery
Isolate/reset
BATTERY (+VE)
9
3