Operating Procedure - Mitsubishi Electric MSZ-AY25VG-ET1 Service Manual

11 DISASSEMBLY INSTRUCTIONS
<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MSZ-AY25VG MSZ-AY35VG
MSZ-AY25VGK MSZ-AY35VGK MSZ-AY42VGK MSZ-AY50VGK
MSZ-AY25VGKP MSZ-AY35VGKP MSZ-AY42VGKP MSZ-AY50VGKP
NOTE: Turn OFF the power supply before disassembly.

OPERATING PROCEDURE

1. Removing the front panel and the panels
(R/L/F/U)
Removing the front panel (Photo 1, Figure 1)
(1) Lift the front panel until a "click" is heard.
(2) Hold the hinges and pull to remove the front panel
(Figure 1).
(3) Remove the horizontal vanes.
Unlock the stopper and remove the horizontal vanes
using following tool like a screw driver.
Unlock
OBH932
(2) The terminal with this connector shown below has the
Slide the sleeve.
Pull the terminal while
pushing the locking lever.
MSZ-AY42VG
Photo 1
Figure 1
Upper
Lower
45
locking mechanism.
Hold the sleeve, and
pull out the terminal slowly.
Connector
MSZ-AY50VG
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
PHOTOS/FIGURES
Front panel
Horizontal vane (L)
Hinge
Hole
Photos: MSZ-AY42VGKP
Horizontal vane (U)