After Operation; After Operation Safety; Cleaning Under The Machine - Toro Proline Recycler PRO530 Manual

If the finished lawn appearance is unsatisfactory, try 1
or more of the following:
•
Sharpen the blade.
•
Walk at a slower pace while mowing.
•
Raise the cutting height on your machine.
•
Cut the grass more frequently.
•
Overlap cutting swaths instead of cutting a full
swath with each pass.
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than a single pass over the leaves.
•
For light leaf coverage, set all the wheels at the
same cutting-height setting.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.

After Operation

After Operation Safety

General Safety
•
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.
•
Close the fuel valve before loading the machine
for hauling.

Cleaning under the Machine

To ensure the best performance, keep the underside
of the machine clean. Be especially careful to keep
the kickers free of debris
1. Kickers
Washing Method
Service Interval: After each use
WARNING
The machine may dislodge material from
under the machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) while the engine is running.
• Do not allow bystanders in the area.
1. Move the machine to a paved level surface near
a garden hose.
2. Start the engine.
3. Hold the running garden hose at handle level
and direct the water to flow on the ground just in
front of the right, rear wheel
1. Right, rear wheel
Note:
The blade will draw in water and wash
out the clippings. Let the water run until you
no longer see clippings being washed out from
under the machine.
21
(Figure 21).
Figure 21
(Figure 22).
Figure 22
g240549
g002275