Page 1
NUUGARDEN USA 30inch Fire Pit 6366 Corley Road, Norcross GA 30071. SKU: AF011...
Page 2
DANGER FIRE OR EXPLOSION HAZARD If you smell gas: Shut off gas to the appliance. Extinguish any open flame. If odor continues, leave the area immediately. After leaving the area, call your gas supplier or fire department. Failure to follow these instructions could result in fire or explosion, which could cause property damage, personal injury, or death.
SAFETY INFORMATION SAFETY INFORMATION • Combustible material should not be within 60 inches of the top of the unit, or within 48 inches Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so around the entire unit.
Page 4
HARDWARE SAFETY INFORMATION Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied directly by us . Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance.
Page 5
ASSEMBLY INSTRUCTIONS CONTENTS 1. Connect the tank holder/base (I) With table Lets(A/B/C/D) by 4pcs screws (R) and 4pcs M6 washers(Q) 2.Connect paenl (E,F,G)with table legs(A,B,C,D) by 12pcs screws (O) and 12pcs M6 washers(Q). Item Description 3. Place the table(L) upside down on a soft surface.
Page 6
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 6. Place propane gas tank (not included) into the 4 .Fasten the door panel (H) to the Table leg (D) metal stand (I). Make sure the gas tank sits on the with screws (O). metal stand (I) completely. 7.
MAINTENANCE OPERATION Carefully remove all items from the carton. Be sure all packaging, both under the fire pit and around the fire bowl, is removed before using. • Before performing any maintenance always disconnect propane gas tank. Locate the battery and remove from plastic. Unscrew the •...
TROUBLESHOOTING Problem Cause Solution Igniter pin and burner are wet Dry off with a soft cloth Igniter battery is incorrectly inserted Check which direction the battery is inserted Contact us. for a replacement part Igniter pin is broken Heating unit won’t light Electrode wire is loose or disconnected Reconnect wire to the igniter box located inside the fire pit behind the igniter box...
Need help?
Do you have a question about the AF011 and is the answer not in the manual?
Questions and answers