2. Setting up the monitor
Warning
• To avoid potential screen damage, such
as panel peeling, ensure that the monitor
does not tilt downward by more than -5
degrees.
• Do not press the screen while adjusting the
angle of the monitor. Grasp only the bezel.
2.3 Remove Base Stand
Remove the Base Stand
Before you start disassembling the monitor
base, please follow the instructions below to
avoid any possible damage or injury.
1. Place the monitor face down on a smooth
surface, taking care to avoid scratching or
damaging the screen.
2. Press the locking clips to detach the base
stand away from the base column.
3. Detach the base column.
1
2
8
Note
This monitor accepts a 100mm x 100mm VESA-
Compliant mounting interface.
100mm
Caution
For use only with UL Listed Wall Mount Bracket
with minimum weight/load 3.5Kg
* Display design may differ from those
illustrated.
Warning
• To avoid potential screen damage, such
as panel peeling, ensure that the monitor
does not tilt downward by more than -5
degrees.
• Do not press the screen while adjusting the
angle of the monitor. Grasp only the bezel.
100mm
0°
-5°
90°