Table of Contents
Advertisement
Connecting module to PC
Connect the Raven module to a PC using a cable with a micro USB connector inserted into the micro USB
connector on the Raven 2 PRO. When connected to the PC the module will power up and will create a
new Virtual COM port.
Run RC electronics device tool software (published on our website under Download / Software section)
Select correct COM port and then press select.
-
to edit setting, you must press Save button to store it in device
-
to download flight, select it from a list in Logbook section and press Download. Empty button will
erase logbook.
Important settings:
Telemetry pair key:
Enter here yours ground unit serial nr to
have a valid RF link.
Telemetry:
rd
Select which 3
party telemetry protocol
will be used on Servo connector.
Servo channel:
Servo channel for servo control. If -1 is used
then normal PWM servo input on device is
used, else servo channel from 3rd party
telemetry data will be used for servo pulse
measurements.
Following units are set in Albatross and will
be synced via RF link. Set them only in case
of standalone usage or no RF link usage.
TE Level:
Level of electronics compensation used.
Vario filter:
Vario response time in seconds.
Servo trigger:
Servo trigger in % for arming the task for GPS triangle flying. When such level of servo pulse is detected,
additional record is stored in IGC file
Raven
- Onboard air-data measuring system for R/C planes with telemetry.
2 PRO
Page 9
Advertisement
Table of Contents
