Advertisement
Dimplex Optiflame Fire
Models: FGA15E, MMZ15E, MCFP15O-E
Thank you for choosing a Dimplex electric fire.
General Information
Unpack the heater carefully and retain the packaging for possible future use, in the event of
moving or returning the fire to your supplier.
These models are designed to be free standing and are normally positioned against a wall.
The fire incorporates a flame effect, which can be used with or without heating, so that the
comforting effect may be enjoyed at any time of the year. Using the flame effect on its own only
requires little electricity.
Before connecting the heater check that the supply voltage is the same as that stated on the
heater.
Please note: Used in an environment where background noise is very low, it may be possible to
hear a sound which is related to the operation of the flame effect. This is normal and should not
be a cause for concern.
Technical Information
Model No:
FGA15E, MMZ15E, MCFP15O-E
Heat Output
Nominal Heat Output
Minimum Heat Output
Maximum Continuous Heat Output
Auxiliary Electricity Consumption
In Standby Mode
with mechanic thermostat room temperature control.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the heater must
correspond to the supply voltage. Before switching on, please read the safety warnings and
operating instructions.
Operating The Product
Controls - see Fig. 2
Three switches provide a choice of heat settings, The appliance is in standby mode when the
mainslead is plugged in. This is indicated by the red neon behind the flame effect screen. The
two selector switches are in the ON position when the switches with the markings on (i.e. I, or
II) is pushed in.
Push button switch 1 (
If both selector switches 2 and 3 are in the OFF position, the product
works on flame effect only.
P
P
P
el
)
Controls the electricity supply to the
appliance and flame effect.
230V
1.3
Nom
0.7
min
1.3
max.c
0.37
SB
240V
1.4
kW
0.7
kW
1.4
kW
0.41
W
Advertisement
