Thermaco Big Dipper 51000 Series Manual

Please scan QR code to review a video
tutorial.
1. Scan this QR code to watch a video tutorial.
1. Scan this QR code to watch a video tutorial.
1. Unplug the center module and remove from
Big Dipper tank.
3. Unplug the center module and remove
from Big Dipper tank.
3. Unplug the center module and remove
from Big Dipper tank.
3. Use the needle nose pliers to straighten out
the legs of the cotter pin and push the pin
5. Use a Phillips head screwdriver and turn
through the shaft.
counterclockwise to remove (5) bolts. Set
5. Use a Phillips head screwdriver and turn
bolts aside.
counterclockwise to remove (5) bolts. Set
bolts aside.
Thermaco, Inc. • 646 Greensboro St. • Asheboro, N. C. 27204-2548 • Phone (336) 629-4651
Thermaco, Inc. • 646 Greensboro St. • Asheboro, N. C. 27204-2548 • Phone (336) 629-4651
51000 Series
51000 Series

Replacing M-58 Motor

Tools required to Replace a M-58 Motor:

Phillips head screwdriver, needle nose pliers,
2. You will need a Phillips head screwdriver
5/16 nut driver, and 3/32 Allen wrench.
driver and a replacement EEC (Electrical
2. You will need a Phillips head screwdriver
Enclosure Cover).
driver and a replacement EEC (Electrical
Enclosure Cover).
2. There will be (4) bolts on the front and (1) in
the rear. Use a Phillips head screwdriver and
4. There will be (4) bolts on the front and (1)
turn counter-clockwise to remove (5) bolts. Set
in the rear.
bolts aside.
4. There will be (4) bolts on the front and (1)
in the rear.
4. Remove the Skimming Wheel Assembly
and shaft then set to the side.
6. Lift the skimming wheel cover and start
prying open the EEC cover. Pull upwards
6. Lift the skimming wheel cover and start
until EEC is completely removed from
prying open the EEC cover. Pull upwards
center module.
until EEC is completely removed from
center module.
1