Battery Charging; Battery Installation - Walker T23 Operator's Manual

Assembly Instructions

Battery Charging

BATTERIES PRODUCE EXPLOSIVE GASES
● Charge the battery in a well-ventilated
area, so that gases produced while
charging can dissipate.
Keep sparks, flames, and smoking ma-
●
terials away from the battery at all
times.
● Make sure the battery charger is un-
plugged before connecting or discon-
necting cables to the battery.
1. Disconnect the battery terminals–negative (-)
first.
2. Charge the battery at 15 amps for 10 minutes.
DO NOT exceed 20 amps (maximum recom-
mended charging rate). Total charging time
should not exceed one (1) hour.
3. Reconnect the battery terminals starting with
the positive (+) terminal.
20
DANGER

Battery Installation

IMPORTANT: Make sure battery is securely
mounted in the frame. A loose battery may cause
damage to the case resulting in acid leakage and
severe damage to the machine. A hazard may be
created by damage to critical working parts and
safety systems.
Install the battery in the mower as shown in Bat-
tery Installation photo. Connect the positive (+)
first and then the negative (-) cable to the proper
battery terminal [red cable and boot connects to
the Positive (+) terminal]. Slide the rubber boot
up and over the battery post, making sure it covers
the post completely to prevent an electrical
short.
Battery Clamp
Secured by
Wing Nut(s)
Battery Installation
T23
(+) Battery Cable
Connection