Maintenance - Husqvarna WDC 220 Operator's Manual

1. Make sure that the main switch is in position "0".
(Fig. 10)
2. Do a check that correct filters are in position in the
product.
3. Put the hose into the vacuum inlet at the front of the
product. Push the hose forward until it is installed
tightly in position in the vacuum inlet. (Fig. 16)
4. Connect the two extension tubes with the handle.
Twist the extension tubes to make sure that they are
correctly in position.
5. Attach a nozzle to the extension tube. Select the
nozzle after the type of material that is to be cleaned.
6. Connect the plug into the mains.
7. Put the main switch into position "I" to start the
product. (Fig. 17)
To stop the product
1. Put the main switch into position "0" to stop the
product.
2. Disconnect the plug from the mains. (Fig. 10)
To use the blow function
1. Put the hose in the opening on the rear of the
product. (Fig. 21)
2. Connect the plug into the mains.
3. Put the main switch to the "I" position. (Fig. 17)
4. Adjust the blow power on the handle or by the main
switch*. *Only on some models. (Fig. 22)
To use the power tool socket*
*Only on some models.
CAUTION:
instructions and safety instructions for
appliances connected to the power tool
socket.
Note:
The maximum power consumption of the
connected tool is told in section
16 .
1. Make sure that the switch on the power tool is in
position "0". (Fig. 23)
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
562 - 005 -
Follow the operating
Technical data on page

Maintenance

Before you do
2. Disconnect the handle from the hose. Press the
hatches on the hose end (A) and pull out the handle
(B). (Fig. 24)
3. Connect the power tool adaptor. (Fig. 25)
4. Adjust the suction power on the power tool adaptor
or by the main switch*. *Only on some models. (Fig.
26)
5. Connect the hose to the vacuum inlet of the product
and to the power tool. Connect the cable of the
power tool to the electrical connection of the product.
(Fig. 27)
6. Make sure that the switch on the power tool is in
position "0". (Fig. 23)
7. Turn the main switch on the product to the power
tool position (A).
8. Put the switch of the power tool to "I" (B). (Fig. 28)
Note:
You can start and stop the product with the
main switch on the product (A) or on the power tool
(B).
To clean liquid
Note:
The product has a float system that stops the
airflow through the product at the maximum liquid level.
CAUTION:
the float system in position.
1. Make sure that the filter and the filter tension (the
float system) is in position, see
on page 14 . Remove the filter bag if it is installed.
2. Use the floor nozzle to clean liquid.
3. At the maximum liquid level, a noticeable change
of the motor sound is heard. The suction power
decreases.
4. Stop the product, see
13 .
5. Empty the dirt container, see
container after liquid pick up on page 14 .
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
Regular service and inspection
• Regular service and inspection of the product must
be done by qualified personnel referring to related
legislation and regulations.
Do not clean liquid without
To replace the filter
To stop the product on page
To empty the dirt
13