Quasar Science Rainbow 2 Quick Start Manual page 15

Rainbow 2
Control Address
Displays the DMX address or IP address of the Light
SubStatus Screens
While viewing the Main Status Screen, a single tap of the Power Button will bring up a Sub-Status Screens with additional information. Additional presses of enter will
advance to the next screen.
1. Color Status Screen - Our Chromaticity Chart and output settings of the light. This displays the live Spectral distribution of the output of the light of Pixel 1 of
the Light. It also displays the Values of the light being produced based on the profile of the light: XY coordinates, RGB values, HSIC+
2. Wired Network information (Wired Art-Net or sACN mode) - When the light is set to recieve Art-Net or sACN, it will displays the IP and Subnet mask settings
and universe of the current network protocol being received. When the light is set to receive DMX, it will display the DMX refresh rate and the current DMX
status.
3. Wireless Network information (Wifi mode) - Displays the IP and Subnet mask settings and universe. In STA mode this screen will also display the SSID of the
network the fixture has joined. In AP mode this screen will show the fixture is broadcasting the SSID.
4. Hardware Status Screen - Displays all of the software installed on the fixture, Bootloader, Wifi Module, Timo2 Module and the internal temperature the fixture.
NOTE
The hardware status screen will display a T if the Timo module needs a firmware update
NOTE
The hardware status screen will display an ! if the Wifi module needs a firmware update
15