Start-Up Checklist - Bryant 524J 07 Installation, Start-Up And Service Instructions Manual

Hide thumbs

Table of Contents

NOTE: To avoid injury to personnel and damage to equipment or

property when completing the procedures listed in this start-up check-

list, use good judgment, follow safe practices, and adhere to the safety

considerations/information as outlined in preceding sections of this

Installation, Start-Up, and Service document.

I. PRELIMINARY INFORMATION

OUTDOOR: MODEL NO. _________________________

SERIAL NO._______________________________

ADDITIONAL ACCESSORIES _______________________________________________________________________

II. PRE-START-UP

OUTDOOR UNIT

IS THERE ANY SHIPPING DAMAGE? (Y/N)_____________

IF SO, WHERE:__________________________________________________________________________________________

__________________________________________________________________________________________________

WILL THIS DAMAGE PREVENT UNIT START-UP? (Y/N)_______

CHECK POWER SUPPLY. DOES IT AGREE WITH UNIT? (Y/N)________

HAS THE GROUND WIRE BEEN CONNECTED? (Y/N)________

HAS THE CIRCUIT PROTECTION BEEN SIZED AND INSTALLED PROPERLY? (Y/N)_________

ARE THE POWER WIRES TO THE UNIT SIZED AND INSTALLED PROPERLY? (Y/N)__________

HAVE COMPRESSOR HOLDDOWN BOLTS BEEN LOOSENED? (Y/N)___________

CONTROLS

ARE THERMOSTAT(S) & INDOOR FAN CONTROL WIRING CONNECTIONS MADE & CHECKED? (Y/N)_________

ARE ALL WIRING TERMINALS (including main power supply) TIGHT? (Y/N)______________

HAVE OUTDOOR UNIT CRANKCASE HEATERS BEEN ENERGIZED FOR 24 HOURS? (Y/N)_________

INDOOR UNIT

HAS WATER BEEN PLACED IN DRAIN PAN TO CONFIRM PROPER DRAINAGE? (Y/N)_________

ARE PROPER AIR FILTERS IN PLACE? (Y/N)______________

HAVE FAN AND MOTOR PULLEYS BEEN CHECKED FOR PROPER ALIGNMENT? (Y/N)___________

DO THE FAN BELTS HAVE PROPER TENSION? (Y/N)_____________

PIPING

HAS FOAM SHIPPING BLOCK BEEN REMOVED FROM THE TXV (Thermostatic Expansion Valve)? (Y/N)__________

ARE LIQUID LINE SOLENOID VALVES LOCATED AT THE INDOOR UNIT (524J***A) OR OUTDOOR UNIT

(524J***H) COILS AS REQUIRED? (Y/N)___________

HAVE LEAK CHECKS BEEN MADE AT COMPRESSORS, CONDENSERS, INDOOR COILS,

TXVs (Thermostatic Expansion Valves) SOLENOID VALVES, FILTER DRIERS, AND FUSIBLE PLUGS

WITH A LEAK DETECTOR? (Y/N)____________

LOCATE, REPAIR, AND REPORT ANY LEAKS. ______________

HAVE ALL COMPRESSOR SERVICE VALVES BEEN FULLY OPENED (BACKSEATED)? (Y/N)_____________

ARE THE COMPRESSOR OIL SIGHT GLASSES SHOWING CORRECT LEVELS? (Y/N)____________

Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.