Propur Scout II Instructions

Clean your system:

* Remove filter package before washing.
1. Wash your hands.
2. Use liquid dishwashing soap along with the
yellow side of the included scrubby sponge to
clean the (a)(b)(c)Scout II housing.
Scout II is also dishwasher safe.
Installing the lter element:
1. Remove the filter and hardware from package.
2. Hold the filter by the plastic base. Run
the ceramic under cool running water.
3. Scrub the filter with the rough(green) side of
the enclosed scrubby sponge. Rinse well
Warning: Do not use any soap on the filter. Do
not allow water to go up the stem of the
filter.
4. Place the (d1)washer onto the stem of the
filter.
5. Place the (d)filter stem through the hole in
upper container.
6. Install (d2)wing nut on the underside of upper
container. DO NOT OVER TIGHTEN.

To use your system:

* Place (b)upper container onto (c)lower
container.
1. Fill the upper container with potable water.
Cover with (a)lid. Allow water to pass through
the filter.
2. We recommend you cycle water 2 times and
discard before using.
WARNING: KEEP AWAY FROM DIRECT SUNLIGHT
Use lid
upside down
as a stand
for the upper
container.
Propur Scout II
®
Instructions
TM
(b)
(a)
(d2)
(d)
(c)
(a)
(b)
(d1)
(d2)
(c)