Advertisement
5
Fitting the Weather Protector
The weather protector provides a weather-resistant shield for the camera's Ethernet connector to prevent
damage from moisture, dust, and other external factors that could interfere with the electrical connection. We
also recommend you seal the joins with electrical tape to ensure a more weatherproof seal.
1.
Place the Rubber-O-ring around the Camera
Ethernet Connector.
2.
Carefully push the Ethernet Cable through the Seal
Cap and then the Seal Tube.
3.
Connect the RJ45 Connector on the Ethernet Cable
to the Camera Ethernet Connector ensuring the
locking tab securely clicks in.
4.
Align the lugs inside the Seal Tube to the Camera
Ethernet Connector, then rotate the Seal Tube to
lock it in place. The Rubber O-ring should become
Rubber O-seal
RJ45 Connector
Camera Ethernet
Connector
Seal Tube
slightly bulged when the Seal Tube has been correctly
connected.
5.
Gently open the pre-cut slit of the Foam Weather
Seal and wrap it around the Ethernet Cable between
the Seal Tube and the Seal Cap. Push this into the
Seal Tube until it is almost all the way in.
6.
Firmly push the Seal Cap over the end of the Seal
Tube and rotate it clockwise to screw it on to the Seal
Tube. Continue to tighten until the Foam Weather
Seal bulges slightly from the end.
Foam Weather Seal
Ethernet Cable
Seal Cap
Advertisement
