Navigating Between Modes
Press (C) to cycle between modes.
After performing operations in any mode,
●
press (C) to return to the Timekeeping
Mode.
Timekeeping Mode
C
Stopwatch Mode
Timer Mode
C
Viewing the Face in the Dark
The watch has a light that illuminates the face
for viewing in the dark.
Turning On Display Illumination
●
Press (D) to turn on illumination.
Illumination will turn off automatically if an
●
alarm starts to sound.
Important!
Frequent use of illumination will run
●
down the battery.
Note
Display illumination is disabled when
●
any one of the conditions below exists.
Alarm, timer alert, or other beeper
ー
sounding
Watch Operation Guide 3523
Time Adjustment
Use the procedures in this section to adjust the
date and time settings.
C
Alarm Mode
Adjusting the Current Time
Setting
Use the procedures in this section to adjust the
C
date and time settings.
Setting the Time/Date
●
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Press (A).
This causes the seconds to flash.
3.
Keep pressing (C) until the setting you
want to change is flashing.
Each press of (C) moves the flashing to
●
the next setting in the sequence shown
below.
Seconds
Seconds
Hours
Minutes
Year
Month
Day
4.
Configure the date and time settings.
While the seconds are flashing,
●
pressing (B) resets them to 00. 1 is
added to the minutes when the current
count is between 30 and 59 seconds.
For all the other values, use (B) to
●
change the flashing setting.
Holding down (B) scrolls through
settings at high speed.
5.
Repeat steps 3 and 4 to select time and
date settings.
6.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Switching between 12-hour and 24-
●
hour Timekeeping
You can specify either 12-hour format or 24-
hour format for the time display.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Press (A).
This causes the seconds to flash.
Seconds
3.
Press (D) to select [PM] (12-hour
timekeeping) or [24H] (24-hour
timekeeping).
12-hour timekeeping
24-hour timekeeping
4.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
6