Advertisement
Step 1
It is a good idea to make check Probe Diagnostic page part of your flight check.
All
green
is good to go and
Best to spot a problem on ground rather than on rotation on take-off.
Step 2
If you need to increase the EGT bar height, for better visablity.
Push SEL and by turning SEL knob (This is preset from factory)
Second push you can set target threshold for leaning by turning SEL knob. (Preset at Insight at 50
Push again to save and yellow screen will disapear.
red
means there is a probe problem.
)
F
Advertisement
