FORM & REFINE POSITION BENCH 155 Assembly Manual
  1. Manuals
  2. Brands
  3. FORM & REFINE Manuals
  4. Indoor Furnishing
  5. POSITION BENCH 155
  6. Assembly manual

FORM & REFINE POSITION BENCH 155 Assembly Manual

Hide thumbs
1
2

Advertisement

Table of Contents

P O S I T I O N B E N C H 1 5 5
Assembly guide

STEP 1

Place the seat bottom up on any larger table.
To protect the surface from scratches lay a
piece of textile or cardboard under the seat.

STEP 2

Place the leg frames above the bushings.
Using the included hex key, mount the screws
in the seat. Tighten the screws properly,
though without fully tightening them.

STEP 3

Place the two brass parts on the seat and
mount the short brass screws. Tighten
the screws with a flat-head screwdriver.
Important note: Brass is softer than iron,
therefore be careful not to scratch the screw.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POSITION BENCH 155 and is the answer not in the manual?

Questions and answers

Related Manuals for FORM & REFINE POSITION BENCH 155

Summary of Contents for FORM & REFINE POSITION BENCH 155

  • Page 1 P O S I T I O N B E N C H 1 5 5 Assembly guide STEP 1 STEP 2 STEP 3 Place the seat bottom up on any larger table. Place the leg frames above the bushings. Place the two brass parts on the seat and To protect the surface from scratches lay a Using the included hex key, mount the screws...
  • Page 2 P O S I T I O N B E N C H 1 5 5 Assembly guide STEP 4 STEP 6 STEP 5 Place the two dowels in the legs. Good work, you are now done. The screws Place the backrest in the two dowels. Mount might have to be tightened after a while when the two long brass screws in the backrest.

Table of Contents