Fisher & Paykel DISHDRAWER DD24SAX9 Installation Manual page 13

SERVICE ACCESS
Service holes can be created on either side of the DishDrawer™ Dishwasher cavity as
z
shown below.
If the hole is created through wood, ensure the edges are smooth and rounded.
z
If the hole is created through metal, ensure the edge protector is fitted.
z
SERVICE HOLE DIMENSIONS
A Maximum distance between rear of cavity and service hole
B Maximum distance between shelf and service hole
C Minimum diameter of hose service hole
D Maximum diameter of power cord service hole
*for assisted opening installations, maximum distance should be referenced from the top of the spacer blocks
CABINETRY PREPARATION
A
C
D
REAR
PROFILE
B WALL
SHELF*
INCHES MM
1/4 5
1/2 10
2 1/4 57
1 1/2 38
MOISTURE PROTECTION
1
3/8"
(10mm)
SIDE PARTITION
1
SELECT CABINETRY SECURING METHOD
METHOD A
Secure to cabinetry via brackets
Recommended method*
*frameless cabinetry only
Align the supplied moisture protection
tape to the cabinetry as illustrated
Ensure this area is free of debris
before carefully applying the tape to
the surface.
If securing via the drawer removal method,
ensure the marked locations provide
adequate support.
If there are no side partitions, construct timber
bracing to secure the fixings to.
METHOD B
Secure via drawer removal
13