Fisher & Paykel DISHDRAWER DD24SAX9 Installation Manual page 11

You have the option to hard-wire your DishDrawer™ Dishwasher. To do this, we recommend
to remove the supplied power cord and do the hardwiring installation as close to the cavity
as possible. Ensure only copper conductors are used.
1
2
3
4
HARD-WIRING (OPTIONAL)
Open the drawer and press both
locking tabs back to release.
Lift the drawer off the runners and
carefully set aside on a protected
surface. Push runners back in.
Take care not to pull drawer out too
far to prevent any strain on the hoses.
Where possible, protect the base of the
tub to prevent damage.
With a flat-bladed screwdriver, push in
the clips and slide out the access cover.
With a screwdriver, unclip the plastic
harness cover and hinge open.
5
6
7
8
Slide the terminal block cover sideways
to unlock and hinge open to access the
terminal block.
Unscrew the Live, Neutral and Earth
wires as shown.
Safely cut the cord from the inside
and outside of the product to remove
the cord.
Fit a suitable cable clamp for the
conduit through the metal knockout.
Ensure wiring is routed through or under
under housing ribs.
11