Determination Of Distance; Problems And Solutions - Blancone ARCUS+ Instructions For Use Manual

X. DETERMINATION OF DISTANCE TO PATIENT'S TEETH
5 cm distance
5 cm distance
XI. PROBLEMS AND SOLUTIONS
The device does not work.
Check if the power cord from the adapter is plugged into the power network and all cable connectors are correctly
coupled.
Damaged power cord.
Do not use the device! Switch it off and replace the cable with new one or take the device to the service facility.
Unpleasant or irritating thermal sensation by the patient.
Increase the distance of the device to the patient's teeth to 10-15 cm. If the thermal sensation is still unpleasant at this
distance switch to low intensity- "Lo" (Low) and shorten the distance to the teeth.
The display is blinking and no light is emitted.
The device is in PAUSE mode. To resume operation, press either (+) or (–) TIMER button.
The Bleaching Head cannot be fixed.
Tighten the fixing ball until the desired head position is reached (see Chapter V., point 5).
The display only shows "Oh".
The device has protection against overheating, and is activated if the temperature in the emitting head rises. Then the
light stops, the display shows "Oh" - Overheating - and the fans work for 1 minute. After cooling, the device returns to
normal operation. Overheating can only occur in an emergency or when the cooling openings are blocked. Therefore,
A
the cooling openings in the lower part of the radiating head must always be free for air circulation.
O
For all other questions regarding installation and operation of the BLANCONE
your local dealer.
E
O
HIGH intensity
LOW intensity
CLICK
ARCUS
LIPS
ARCUS
DUETTO
CARE
9 cm distance
9 cm distance
15 cm distance
15 cm distance
® ARCUS , contact the manufacturer or
+
LED Bleaching Lamp - FIXED
GB
Hot
Warm
Accetable
Weak
15