Table of Contents
Advertisement
7) After the NSCaster-X1 device is started, it will enter the main interface of NSCaster-X1 as shown
in the following figure:
8) The SDI video signal and HDMI video signal are directly loaded into the main interface.
9) To load NET signal, select "
edit box.
10) To load DDR signal, select the DDR button in the DDR alternate video window, and select one of
the video sources, then click Play to load the video into the DDR channel.
11) Select the output channel and press the record button "
12) To start switching, tap once on the channel you want (SDI-1,SDI-2,HDMI-1,HDMI-2,NET,DDR) and
it will switch to PGM.
13) Start uploading the picture on PGM as shown below:
14) Press again the record button to stop recording.
15) Check whether all the recording files are normal. The recording file is saved in the "Recording"
folder which located at the "File Transfer" interface.
16) Press the Power On/Off button to turn off the NSCaster-X1 device.
17) Turn off the power switch of the device, unplug the power supply, and unplug all input and
output video cables and antennas, then keep the NSCaster-X1 device properly.
" in the NET channel and enter the stream in the pop-up stream
7
" to start record.
Advertisement
Table of Contents
