Maytag MSB2654HE Use And Care Manual page 9

Installation
Installing Front-Mounted Handles for
Stainless Steel
1. Loosen lower door clip on door with
1 " hex nut driver.
⁄
4
2. Locate predrilled hole at base of
handle, and fit hollow end of
handle over lower door clip.
3. Fit other end of handle over upper
door clip and slide up as far as
possible.
NOTE: If top of handle does not
fit over top clip, loosen lower clip
further until fit can be
accomplished.
4. Insert " hex nut driver into
1
⁄
4
predrilled hole at base of handle
to tighten screw. Insert screw
plug into hole, as illustrated.
5. Repeat above steps to install
other handle.
Removing Front-Mounted Handles for
Stainless Steel
1. Remove plastic button plug at
base of handle with a very small
flat-blade screwdriver.
• Insert 1 " hex nut driver into
⁄
4
predrilled hole to remove
screw.
2. Slide handle down and remove
from bottom door clip.
3. Repeat above steps to remove
other handle.
8