Warnings and Cautions Please retain this instruction for future usage and read carefully before assembly. Make sure you have all the parts & hardware as item list shows. 2 adults or more are recommended to install your pergola. Do not discard any of the packaging until you have checked that you have all the parts and pack of fittings.
Page 3
You may need 2 ladders. Use the hex keys in the box. You may need to Do not tighten use a drill for this step. screws all the way for now. Use something soft(like carpet) Two or more people as a surface for setting up the are required at this stage.
Page 4
MOUTING MOUTING BLUEPRINT BLUEPRINT Pergola 10'x12' Pergola 10'x13' 5.11 in. 5.11 in. 125.78 in. 139.56 in. 5.11 in. 5.11 in. 97.83 in. 97.83 in.
Page 6
4 inches 1/4 inch ×16 If the ground is concreted and the depth of it is over 3 inch , you can use 1/4 inch expansion bolts to mount the pergola IMPORTANT: 15 inches Anchor is not recommended Or you can make a concrete footing 15×15×15 inches for pergola ,...
Page 7
IMPORTANT: make sure A1&A2 are at right positions as the canopy operates in picture shows.
Page 28
Connect the cross beam ( E & E1 ) and (F ×6 & F1) with the main beam . Attention: Always keep P and C / C /C1 in the C2 C1 same side. STEP 5...
Page 32
×10 Stabilize H / HI to the N hook & with J bolt. Pull the rope of the canopy and put on N hook to tighten the canopy, as the picture shows below. STEP 6...
This warranty does not cover products subject to negligence, abuse usage, inappropriate installation, extreme weather condition. Purple Leaf reserves the right to explain warranty exclusions. When the replacement item is applied, the 1 year warranty automatically expires. Please feel free to contact us to...
Care and Cleaning When not in use, close and cover pergola with a protective cover. If necessary, clean the fabric with lukewarm water. Allow a wet canopy to dry slightly opened, but do not leave unattended. Wipe sliding marks on the aluminum poles with a damp cloth. Winter Storage: Store In A Dry Place.
Need help?
Do you have a question about the ZYMPG1013 and is the answer not in the manual?
Questions and answers
How would I get part labeled N on your instructions?