Advertisement
VANCE & HINES SYSTEM INSTALLATION
1. Install A790ST-P onto muffler as show. (Fig.1)
2. Slide provided barrel clamp over new V&H muffler, slip muffler onto stock mid-pipe.
(Leave clamp loose). Make sure that barrel clamp bolt is accessible from bottom.
3. Line up muffler bracket to bike mount and install supplied M8x1.25 screw and flange
nut finger tight
4. Tighten M8 muffler bracket mounting bolt to nut
5. Align muffler and rotate barrel clamp to be as out of sight as possible, align with
leading edge of muffler and tighten.
6. Install hose clamp ( item 4) onto heat sheild
7. Install heat shield onto muffler mid pipe and tighten hose clamp.
8. Be sure all hardware is tight. Before starting the motorcycle, completely clean tail pipes
and mufflers with warm soapy water and a clean soft cloth that will not leave residue.
Dry with a clean towel. NOTE: Any residue, oil, or fingerprints will stain the finish when
the exhaust system heats up. Do NOT use anything abrasive to clean black mufflers as it
may remove the finish.
EXHAUST CARE (BLACK)
1. When installing a new set of black pipes, make sure your hands are clean and free
from oil. After installation, thoroughly clean pipes with warm soapy water and a soft
cloth. Dry with a clean towel to remove any residue before starting the motorcycle. Do
NOT use anything abrasive to clean pipes.
2. Avoid long periods of idling as this can cause discoloration.
3. Intake leaks can cause the engine to run lean and overheat, this could lead to
discoloration.
4. Make sure there are no exhaust leaks at the junction of the exhaust pipes and the
cylinder head. We recommend replacing gaskets if they are worn.
Page 3 of 5
H505IN RevD
Advertisement
