Advertisement
Available languages
Available languages
Information notice for knee pads, elbow pads and wrist protections for roller skating, skateboarding or scooter riding.
They offer protections of the limbs mentioned in compliance with the European legislation EN14120 Level 1 A+B.
Size: S (<25kg/<130cm) – Size M (25kg-50kg/130-155CM) – Size L (25kg-50kg/>155cm)
1/Advice for use:
Thank you for choosing these protections that protect you in the event of a fall. It is therefore essential that you remember to use them every time you do roller
sports. Nevertheless total safety cannot be guaranteed even with the best protections. As most experienced skaters know, all falls cannot be controlled. For the
practice of any of these urban roller sports we advise you to wear, in addition to an adapted helmet, all the protections mentioned (knee pads, elbow pads,
wrist protections).
a)
Fitting the knee or elbow pads:
1-
Make sure that the protection marked L is placed on the left knee or
elbow and the one marked R is placed on the right knee or elbow. Make
sure the protections effectively correspond to your size by checking that:
-The protection does not slip or turn
-The wrist is completely protected
-You can move completely freely
2- Undo the self-gripping strips
3- Place the protection on your knee or elbows
4- Thread the self-gripping strips through the plastic buckle and fasten them
5- The knee and elbow pad should be tight enough to avoid slippage and
provide maximum protection.
Caution: Do not fasten them too tightly to avoid blocking your blood circulation
b)
Fitting the wrist protectors:
1-
Ensure that the protector marked L is on the left hand L and the one
marked R is on the right hand.
2-
Make sure the protections effectively correspond to your size by checking
that:
The protector does not slide or turn
-
-
Your wrist is completely protected
-
You can move freely
3-
Undo the self-gripping strips
4-
Slip the hand in the protector with your thumb inserted into hole so that the palm of your hand is alongside the
curved plastic part
5-
The two self-gripping strip should be rolled around the wrist and well fastened. The long strip should be wrapped around your hand. Both
protectors should be tight enough to avoid any slippage and provide maximum protection
Caution: Do not fasten them too tightly to avoid blocking your blood circulation.
Precautions:
-
Before using the protectors, check that all the parts are present and that no anomalies are obvious to the touch.
These protectors are designed for roller sports (roller skates, skateboard or mini-scooters), leisure use. Their protective functions may not be
-
suitable for other sports.
Replace the product immediately if any damage occurs (unglued foam, cracked or broken shell or even dirt...).
-
With each use (frequent knocks, washing, friction during use), the protection may deteriorate. It is then the owner's interest to place it
-
-
Avoid any contact with chemical products or exposure to extreme temperature as this could reduce the protection.
-
If the self-gripping strips lose their adhesive functions, they must be replaced.
Total guarantee period is two years against any manufacturing defect.
-
3/Maintenance and storage:
-
Avoid storing the protection in damp & humid places, near to sources of heat and exposing them to extreme temperatures.
-
Store it in a dry and ventilated place to increase sweat elimination.
Wash by hand in cold water or with a diluted cleaning solution and rinse afterwards in clear water. Leave the protectors to dry at room
-
temperature.
Composition: Nylon, PE /MAS-B023, Nylon, PP/MAS-B022
© COPYRIGHT
MASTER SPORT s.r.o. retains all rights to this Owner´s Manual. No text, details, or illustrations from this manual may be either reproduced, distributed, or become the subject of
unauthorized use for commercial purposes, nor may they be made available to others.
Reproduction prohibited!
Address of local distributor:
User´s manual for protectors - MAS-B022,MAS-B023
EN
Advertisement
