Selecting Heat Mode
You can select Heat mode if you want to heat your room.
You can adjust the temperature and the fan speed when heating.
1
Press the
Result:
2
Press the
Result:
Note
3
Press the
temperature is displayed.
You can set the temperature between 16°C and 30°C.
Result:
4
Press the
displayed.
Result:
5
To control the airflow direction, refer to page 21.
FJM_Neo_FORTE_Inv_28925A_IB_E.indd 15
Get user manuals:
See SafeManuals.com
(On/Off) button.
The operation indicator on the indoor unit lights up.
The air conditioner starts up in the mode you selected last.
The indoor unit beeps.
button on the remote control until
The indoor unit beeps each time you press the
The air conditioner runs in Heat mode.
You can change modes at any time.
button to adjust the temperature until the required
Each time you press the
button:
- The temperature adjusts by 1°C
- The indoor unit beeps
If the room temperature reaches 5°C higher than the set
temperature, the air conditioner stops heating, but the fan
continues to operate.
If the room temperature reaches 3°C lower than the set
temperature, the air conditioner starts heating again.
button to select the fan speed until the required setting is
Automatic (rotated :
Low
Medium
High
Each time you press the
button, the indoor unit beeps.
For the first 3~5 minutes, the fan may not operate to prevent
cool air from flowing out of the indoor unit.
This helps to warm the air in your room sufficiently.
is displayed.
button.
)
15
E-
2007-12-3 19:10:08