Troubleshooting - DeWalt DXV34P Manual

English
Blowing Feature (Fig. C)
Your vac contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or off
patios and driveways. Follow the steps below to use
your vac as a blower.
1. Locate blowing port on your vac.
2. Insert one end of the 48mm x 2.1m hose
into the blowing port.
3. Turn vacuum "ON".
Storage (Fig. A)
1. Empty the canister, refer to Empty Canister
under Operation.
2. Clean the vacuum inside and outside. Refer to
Cleaning.
4. Store the suction hose and the power cord as
shown in the illustration. Place the unit in a dry
room and secure it from unauthorised use.
Optional Accessories
WARNING:
Since accessories, other than those
offered by D WALT, have not been tested with this
E
product, use of such accessories with this appliance
To reduce the risk of injury, only D
recommended accessories should be used with this
product.
CLEANING
outside with a cloth dampened with warm water and
mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild
soap.
3. Wipe out with dry cloth.

TROUBLESHOOTING

WARNING!
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
customer service.
WALT
E
7
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
ON position ( I )
Remove blockages in the suction
Suction capacity
Check for proper installation of the
decreases
Empty canister, refer to
the tank
instructions
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
Vacuum stops
2. Empty the canister, if needed.
running
3. Allow the unit to cool.
4. Plug the power cord into an
switch to the ON position ( I ) to
test.
Check for proper installation of the
Dust comes out
while vacuuming
replace if necessary.
are secure.
If the power cord is damaged, it must
WARNING!
be replaced by the manufacturer, its service agent or
®
10
SOLUTION
Empty
Operating.
under
B