Advertisement
3
Securing the Bumpers and
Right and Left Baffle to the
Mower Deck
Parts needed for this procedure:
4
Carriage bolt (3/8 x 2-1/2 inches)
4
Flange nut (3/8 inch)
Procedure
Note:
To install the bumper bolts, you may need to
loosen the mating baffle and kicker baffle.
1.
Insert 2 carriage bolts (3/8 x 2-1/2 inches) on
each side through the right and left baffle and
bumpers
(Figure
1. Flange nut (3/8 inch)
2. Bumper
3. Carriage bolt (3/8 x 2-1/2
inches)
2.
Secure the 2 carriage bolts using 2 flange nuts
(3/8 inch) on each side
3.
Torque the carriage bolts and flange nuts to 12.4
to 14.7 N∙m (110 to 130 in-lb).
5).
Figure 5
4. Left baffle
5. Right baffle
(Figure
5).
4
Converting Back to Rear
Discharge
No Parts Required
Procedure
1.
Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the finish-cut baffles and kicker baffles.
Retain all the hardware.
4.
Replace the finish-cut blades with standard
blades.
5.
Install the hex-socket screws (5/16 x 3/4 inch)
and the flange nuts (5/16 inch) in the holes
on the top of the deck with the bolt head
underneath.
Note:
You must plug all open holes not covered
by belt shields or the frame to prevent sand
and/or other small objects from being thrown up
through the deck.
g024518
5
-
position, and
EUTRAL
LOCK
Advertisement
